Woodward TG-17E Actuator

Note Uploaded template showed “AG-17”; Woodward source identifies TG-17E. Please verify exact model name before commercial use.
Functions Self-contained electro-hydraulic proportional actuator for steam turbines. Converts DC control signal into proportional rotary shaft movement for steam/control valve positioning. Used for isochronous control, load sharing and other turbine governor functions.
Name Woodward TG-17E Actuator
Auxiliary Voltage Not applicable as a separate auxiliary supply. Electrical command is a DC current signal. Nominal input current: 20–160 mA; maximum allowable current: 400 mA.
Actuator Output Rotary output shaft position. TG-17E work output: 17.5 lb-ft / 23.7 N·m over full governor travel of 42°. Output shaft: 0.625-36 serration on both sides of case.
Digital Inputs N/A – no digital inputs specified for actuator body.
Digital Outputs N/A – no digital outputs specified for actuator body.
Analog Inputs 20–160 mA DC position demand/control signal. Transducer coil resistance: 30–35 Ω at 20 °C. Electrical connector: 4-pin MIL-STD-1651-14S-2P.
Analog Outputs No electrical analog output specified. Output is mechanical proportional shaft position.
CAN Communications Port N/A – CAN communication port not specified.
RS485 Ports N/A – RS485 communication port not specified on actuator body.
Ethernet Port N/A – Ethernet communication port not specified on actuator body.
Mounting Type Vertical or horizontal mounting. Standard calibration is for vertical operation; horizontal operation may shift terminal-shaft calibration by approximately 5°–6°.
Nominal Frequency N/A – actuator is not AC-frequency controlled. Mechanical drive / pump speed ranges are 1100–2400 rpm, 2400–4000 rpm, or 4000–6000 rpm depending on actuator part number.
Degree of Protection Ingress protection / IP rating not specified in available Woodward website source. Optional Class I, Division 2, Groups B, C and D UL-listed versions are referenced in Woodward Product Specification 04044.
Call Us
WhatsApp